Sill & Rafter

Heating, Cooling & Energy

Heating, cooling & energy

How much insulation an attic needs, what a stack of materials adds up to in R-value, how much fresh air a house needs, how far a stovepipe has to stay from a wall, and how to move between the units heating and cooling equipment is rated in.

  • Attic Insulation Calculator

    How much insulation to add to your attic for your climate zone, by ENERGY STAR's figures, and how deep and how many bags of blown insulation that takes.

  • BTU, Watts and Tons Converter

    Convert heating and cooling capacity between Btu per hour, watts, kilowatts and tons, and efficiency between COP and Btu per watt-hour, with NIST's factors.

  • Clearance to Combustibles Calculator

    How far a stovepipe, a gas vent connector or a stove must stay from walls and ceilings, and how much a code-listed shield can reduce it (2021 IRC).

  • Dual Fuel Heat Pump Break-Even Calculator

    The COP at which a heat pump's heat costs the same as a gas, propane or oil furnace's, and the outdoor temperature where the furnace should take over.

  • Duct CFM and Supply Register Calculator

    Blower airflow from the system size, each room's share from its design load, and how many supply registers carry it, from makers' data.

  • HSPF2 Savings Calculator

    How much electricity and money a heat pump with a higher HSPF2 saves on heating, from your bills or your home's seasonal heat load.

  • R-Value Calculator

    Add the R-values of the layers in a wall, roof or floor for the total R-value, the U-value and the heat flow through an area.

  • Whole-House Ventilation Calculator

    The minimum continuous fresh-air rate for a house from its floor area and bedrooms, with the residential code's table, Equation 15-1 and run-time factors.

Units first

Furnaces are rated in Btu per hour, air conditioners and heat pumps often in tons, electric heaters in watts. The converter puts them side by side, so you can compare a quote, a nameplate and an energy bill in the same unit.

Insulation

The attic calculator starts from ENERGY STAR's recommended levels for your climate zone and turns the gap into a depth and a number of bags. The R-value calculator adds layers in series and gives the U-value and the heat flow: the arithmetic behind those recommendations.

Fresh air and stoves

The ventilation calculator reads the residential code's minimum whole-house airflow from the floor area and the number of bedrooms. The clearance calculator gives the distance from a stovepipe, a gas vent connector or an appliance to combustible material, and how much a form of protection listed in the code can reduce it.