Yard & Concrete · Calculator
Lawn Watering Calculator
Enter the area you water, the depth of water to apply each time and how often you water. Add the result of a catch-can test and the calculator gives the run time for the zone as well as the gallons.
Run each zone for
30 minutes
- Each watering
- 1,558 gallons
- Each week
- 3,117 gallons, 1 in of water
- Sprinkler rate
- 1 in per hour
- Run time per week
- 60 minutes
The run time is for the zone you tested. Utah State repeats the test for each zone.
One inch of water on a square foot is 0.623 gallons.
Catch-can method of Utah State University Extension; US gallon from NIST SP 811.
Lawn watering is measured in inches of water. Putting 0.5 inch on 5,000 square feet takes 1,558 gallons, and with sprinklers that apply 1 inch an hour the zone has to run 30 minutes.
Depth, not minutes
Watering advice is given as a depth of water, because the minutes depend on the sprinklers. Utah State Extension, for example, suggests 0.5 inch for each watering of turfgrass in Rich County, Utah, and the University of Florida's extension office in Hillsborough County says not to go over ½ to ¾ inch per watering. How often to water changes with the weather and the season, so the calculator asks for both: the depth each time and the number of waterings a week.
From inches to gallons
An inch of water on one square foot is 144 cubic inches, and a US gallon is 231 cubic inches, so it is 0.623 gallons. On 1,000 square feet, an inch of water is 623 gallons. The calculator multiplies the area by the depth to give the gallons for each watering and for the week.
The catch-can test
To find how fast your sprinklers apply water, set out straight-sided containers of the same size, such as tuna or cat food cans; Florida's extension office suggests 10 or more. Utah State places one near each sprinkler head and one halfway between heads. Run the zone, 15 minutes in Florida's version, then measure the water in each can with a ruler and take the average. The rate is:
inches per hour = average depth in the cans ÷ minutes of the test × 60
If the cans hold very different amounts, some heads need adjusting before the run time means much. Repeat the test for each zone.
A worked example
A lawn of 5,000 square feet gets 0.5 inch of water 2 times a week. Each watering takes 1,558 gallons, 3,117 a week. In a catch-can test, the cans held an average of 0.25 inch after 15 minutes, so the sprinklers apply 0.25 ÷ 15 × 60 = 1 inch an hour, and the zone has to run 30 minutes each time, the same as in Utah State's example.
When to water
Florida's extension office recommends watering in the early morning, between 4 and 6 a.m., to avoid conditions that favor disease and to keep the water from evaporating.
Questions people ask
How long should I run my sprinklers?
It depends on how fast they apply water. Measure it with a catch-can test, then divide the depth you want by that rate: at 1 inch an hour, 0.5 inch takes 30 minutes.
How many gallons does it take to water 1,000 square feet?
An inch of water on 1,000 square feet is about 623 gallons; half an inch is about 312.
How much water does my lawn need?
It depends on your climate, grass, soil and the season. Extension services give it as a depth per watering, such as Utah State's 0.5 inch for turf in Rich County; your county office can give the figure for your area.
Sources
- Utah State University Extension: Simple Sprinkler Performance Testing for Rich County — catch-can placement, precipitation rate formula, 0.5 inch per watering and the 30 minute example
- UF/IFAS Extension Hillsborough County: Catch Can Test (March 2024) — 10 or more cans, 15 minute run, ½ to ¾ inch per watering, early morning watering, local irrigation laws
- NIST Guide to the SI (SP 811), Appendix B.9 — US gallon and cubic inch: 231 cubic inches per gallon